Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving all of Florida

Roll-Up Door Repair in Florida

Sheet roll-up doors for storage units, sheds and warehouses repaired. Typical cost $150-$600.

Our roll-up door repair service in Florida comes down to three things: a clear diagnosis, the right parts on the truck, and a door that is balanced and safety-tested when we finish. Sheet roll-up doors for storage units, sheds and warehouses repaired.

Signs you need roll-up door repair

  • The door is hard to lift or won't stay up
  • A dented or creased curtain
  • The latch won't lock
  • The door comes out of its guides

What usually causes it

  • Loss of spring tension
  • Impact damage
  • Worn latches and stops

Before the technician arrives

  • Check whether the stops at the top of the guides are in place.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

How we handle roll-up door repair

  1. Inspect the curtain, guides and drum
  2. Adjust or replace the springs
  3. Repair the curtain or replace the door
  4. Replace latches and stops
  5. Test it

Roll-Up Door Repair cost in Florida

$150-$600Typical range, parts & labor
1-2 hoursTypical time on site

What moves the price:

  • Door size, gauge and cycle rating
  • Operator type and controls
  • Parts availability for your model
  • Lift equipment and after-hours access

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Serving Florida and nearby towns

Humid air in Florida rusts cables, roller bearings and hinges, which makes the door noisy and heavy and eventually makes the opener strain.

Close to the coast, salt air speeds up corrosion. Galvanized or coated springs, nylon rollers and stainless hardware hold up better than bare steel.

We cover 682 cities and towns across Florida. Find roll-up door repair in your city:

Roll-Up Door Repair: frequently asked questions

How much does roll-up door repair cost in Florida?

Roll-Up Door Repair typically costs $150-$600 including parts and labor, and usually takes 1-2 hours. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do roll-up door repair the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is roll-up door repair covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where Florida or your city requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my commercial door?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the commercial door is near the end of its life, replace it. Commercial doors are rated by cycles. If the door has reached its rated cycle life, has several damaged sections, or parts are no longer made, replacing it is often cheaper over the next few years. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in Florida

Clopay Weather Seal Replacement

Clopay is one of the largest residential garage door makers in North America, with lines such as Classic, Modern Steel, Coachman and Canyon Ridge. The model is usually printed on a label on the door's end stile, which helps us match replacement panels.

Typical $100-$300

Raynor Commercial Garage Door Repair

Repairs for commercial sectional, overhead and service doors.

Typical $250-$1,000

Wayne Dalton Garage Door Panel Replacement

Wayne Dalton is part of the Overhead Door Corporation. Many Wayne Dalton doors use the TorqueMaster spring system, with the springs sealed inside the torsion tube, so spring work needs TorqueMaster parts and a different procedure.

Typical $300-$900

Midland Garage Door Garage Door Repair

Diagnosis and repair for doors that are stuck, noisy, crooked or won't open or close.

Typical $150-$450

Martin Door Torsion Spring Replacement

Torsion springs replaced and wound correctly, with high-cycle upgrades available.

Typical $200-$450

Wind-Rated Garage Doors

Hurricane-rated doors and reinforcement kits for high-wind and coastal areas.

Typical $1,800-$6,000

Garage Door Repair

Diagnosis and repair for doors that are stuck, noisy, crooked or won't open or close.

Typical $150-$450

Richards-Wilcox Garage Door Roller Replacement

Worn steel or plastic rollers swapped for quiet, sealed nylon rollers.

Typical $150-$350

Garage Door Hinge Replacement

Cracked or loose hinges replaced so panels stay aligned and quiet.

Typical $100-$250

Sommer Garage Door Opener Installation

Sommer openers, made in Germany, put the motor on a carriage that travels along the rail instead of hanging from the ceiling, so servicing them is a little different from a conventional opener.

Typical $350-$800

Raynor Garage Door Roller Replacement

Raynor, based in Dixon, Illinois, makes residential and commercial garage doors as well as openers.

Typical $150-$350

Martin Door Weather Seal Replacement

New bottom seals, threshold seals and perimeter stops to keep out water and drafts.

Typical $100-$300

Garage door stuck, noisy or broken?

Talk to a garage door technician in Florida now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call NowFree Quote